37% acid etch Archives - Page 2 of 7

Branch: Restorative-Conservative Dentistry

- 25 March 2026

Biomimetic Direct Restoration of Endodontically Treated Posterior Tooth Using Fiber-Reinforced Composite (EverX) and Giomer Composite

Author: Abdo esmat

Nationality: Egypt

Brand: SHOFU composite A2, Ever x flow, ever x posterior, OptiBond

Material: 37% acid etch, Ever x posterior , Saddle metal for deep margin

Technique: Matrix_in_matrix technique

Introduction Restoring endodontically treated posterior teeth is always a clinical challenge due to significant loss of tooth structure and increased susceptibility to fracture. Modern adhesive dentistry allows for conservative, biomimetic approaches using fiber-reinforced composites to mimic dentin behavior and improve…

456

LIKE LIKE 60

COMMENTS 5

Branch: Endodontics, Prosthodontics

- 13 March 2026

Indirect adhesive restoration on a severely compromised tooth

Author: CamilloMassa

Nationality: Italy

Brand: Tokuyama, Kuraray Noritake, Nictone Rubberdam, 3M ESPE, Ultradent

Material: Estelite asteria a2b, Estelite Universal Flow, 37% acid etch, 9.5% hydrofluoric acid etch from bisco, Lithium disilicate, Aluminum Oxide 50 micron

Technique: Morphology Driven Preperation Technique, Biomimetic, Deep margin elevation, Composite Build Up, Crown-Down Technique, Cuspal coverage technique, RCT using single cone with bioceramic sealer

Tooth 3.6 was severely compromised and was managed with endodontic treatment, deep margin elevation, and an indirect adhesive restoration with full cuspal coverage using a lithium disilicate overlay. Tooth 3.7 presented a large MOD carious lesion, with both distal cusps…

557

LIKE LIKE 43

COMMENT 0

Branch: Restorative-Conservative Dentistry

- 23 February 2026

Reconstruction of the contact point (2.4–2.5).

Author: Vitalik

Nationality: Ukraine

Brand: Estelite Asteria, neospectra, Ever x posterior for dentin replacing material, Eve twist kit

Material: 37% acid etch, Enamel plus, Estelite asteria a2b, Estelite Universal Flow

Technique: 3D printed, Occlusal Reconstruction

Immediately after finishing the final preparation, it was necessary to restore the palatal wall of tooth 2.5. For this, I used a “3D printer” layering technique, gradually rebuilding the wall with a flowable composite (Estelite Universal Flow). The thickness of…

408

LIKE LIKE 54

COMMENT 0

« Previous 1 2 3 4 … 7 Next »